One for All 6-Device Universal Remote - Manual (Page 11)

O NE F OR A LL 6L U NIVERSAL R EMOTE C ONTROL WITH L EARNING
10 Using Macros
1. Press and hold SET until the LED (red
light) blinks twice, then release SET.
2. Enter 9 9 5. The LED will blink twice.
3. Select an open macro key (e.g., M1)
and press it once.
4. Press CBL/SAT once.
5. Enter the channel number: 5 2.
NOTE: If you have access to over 100 channels,
enter 0 5 2. Moreover, if the original remote
control requires you to press ENTER to change
the channel, also press ENTER after the
channel number (e.g., 0 5 2 ENTER).
NOTE: You can program up to 20 functions on
the macro keys.
6. Press and hold SET until the LED blinks
twice, then release SET.
Now when you press M1, you will instantly
see cable channel 52 on your TV set.
P ROGRAMMING A M ASTER P OWER M ACRO
In its default state, the POWER key on the
One For All 6L Universal Remote Control
with Learning (URC-6820 B00) will
individually power your home
entertainment devices on or off. However,
you can also program a Master Power Macro
onto the POWER key that will sequentially
turn on or off all the devices with a single
key press.
To Program the Master Power Macro
1.
Press and hold SET until the LED (red
light) blinks twice, then release SET.
2. Enter 9 9 5. The LED will blink twice.
3. Press the POWER key once.
4. For the first device you want in the
power-on sequence, press its device
key (e.g., TV) once.
5. For the second device you want in the
power-on sequence, press its device
key (e.g., CBL/SAT) once.
6. For the Third device you want in the
power-on sequence, press its device
key (e.g., AUD) once.
7. Repeat step 6 up to three more times to
add the other desired devices to the
power-on sequence (e.g., VCR, DVD,
and PVR ).
8. To save the settings and exit the
program, press and hold SET until the
LED blinks twice, then release SET.
To Operate Master Power Macro
1.
After programming, point the remote
control at the devices and press POWER
for at least 2 seconds to sequentially
turn on (or off) your devices.
NOTE: When you press POWER for less than 2
seconds, a power command will only be sent
to the currently-selected device. This allows
you to still individually power devices on or
off.
2. Devices will turn on (or off) according
to your programmed sequence.
NOTE: The currently-selected device will
always turn on or off first, followed by the
remaining programmed sequence. After the
master power sequence has been completed,
the remote control will be set to control the
first powered-on device.
NOTE: If one or more devices does not have a
POWER key, the power off/on sequence may
be slightly delayed when the remote control
signals the device(s).This action is normal.
P ROGRAMMING A M ACRO ON A D EVICE K EY
In its default state, when you press a device
key (e.g., TV) on the One For All 6L Universal
Remote Control with Learning (URC-6820
OFA 6L with Learning Owners Manual.fm Page 10 Thursday, February 17, 2005 1:10 PM