Oce North America TDS700 User Manual
Page 18
18
Chapter 2 Walk-up user
Turn on and off the Océ TDS700
Illustration
[9]
[9] On/off switch at the rear of the printer
Turn on and off the printer
1.
Set the On/off switch at the rear of the printer to position ‘1’. The green LED turns
on. The message Ready to print appears on the printer operator panel.
Note:
You must separately switch on the controller that is located inside the printer.
2.
Set the On/off switch at the rear of the printer to position ‘0’. This action only turns
off the printer.
Note:
Before you turn off the printer, make sure that the printer is not printing a job.