Onkyo TX-DS898 - Manual (Page 53)

53
To record the input source signal you are
currently watching or listening to
This method outputs to the audio and video outputs the currently
selected input source signal. This method allows you to a signal
while you are actually listening to or watching it.
1. Select the input source to record by pressing the
corresponding input source button.
The input source is now selected and you may watch or listen to
it as desired.
2. Press the REC OUT button repeatedly until “Rec
Sel:SOURCE” appears in the front display.
The currently selected input source signal to the TAPE OUT,
VIDEO 1 OUT, VIDEO 2 OUT outputs for recording.
Recording a source
Notes:
• If you change the input source during recording, you will record
the signals from the newly selected input source.
• You cannot record the surround effects.
• Digital signals input to the DIGITAL INPUT (COAXIAL) and
DIGITAL INPUT (OPTICAL) inputs will be output to the
DIGITAL OUTPUT (OPTICAL) output.
• Digital input signals are only output to the digital outputs and
analog input signals are only output from the analog outputs.
There is no conversion from digital to analog or vice versa.
When connecting CD players and other digital components, do
not connect only the digital terminals, but the analog ones as
well.
• There are some restrictions on recording digital signals. When
making digital recordings, consult the instruction manual that
came with your digital recording equipment (e.g., MD recorder
or DAT deck) to know what restrictions are imposed.
• You cannot record the source connected to the MULTI
CHANNEL INPUT connector.
Input source buttons
STANDBY/ON
OFF ON
POWER
STANDBY
MASTER VOLUME
FM AM PHONO C D TAPE DVD VIDEO 3 VIDEO 5 VIDEO 4 VIDEO 2 VIDEO 1 ZONE 2 ( ) GRN REC ( ) RED AUDIO SELECTOR DISPL AY PURE AUDIO UPSAMPLING
PHONES
ZONE 2 LEVEL
STEREO SURROUND THX DSP REC OUT ZONE 2 OFF DIMMER FM MODE MEMORY SETUP
CLEAR
ENTER RETURN VIDEO 5/VIDEO CAM INPUT
TUNING PRESET S VIDEO AUDIO VIDEO L R DIGITAL
REC OUT
3. Start recording at the recording component as
desired.
To confirm the settings, press the Rec Out button. The current
settings will appear for 3 seconds in the front display.