Onkyo Remote Interactive Dock for iPod/iPhone DS-A4 - Manual (Page 13)

13
■ Using Your iPod/iPhone model’s Alarm
Clock
You can use your iPod/iPhone model’s Alarm
Clock function to automatically turn on your
iPod/iPhone and amp at a specified time. Your
amp’s input source will automatically be set to
the input to which your iPod/iPhone is con-
nected.
■ Charging Your iPod/iPhone model’s Bat-
tery
The RI Dock charges your iPod/iPhone model’s
battery while your iPod/iPhone is in the RI
Dock.
If you cannot adjust the volume of your Onkyo
component with the DS-A4’s remote controller,
try changing its remote control ID. The default
setting is #1.
Some Onkyo components are set to ID #2 or #3.
• While pressing and holding down the
[SETUP] button, press one of the following
buttons for more than 3 seconds to set the
ID:
ID #1: PLAYLIST Up [
] button
ID #2: ALBUM Up [ ] button
ID #3: PLAYLIST Down [ ] button
ID #4: ALBUM Down [ ] button
Notes:
• This function only works when the OSD
mode is set to Off.
• To use this function, your iPod/iPhone
must be in the RI Dock, and the RI Dock
must be connected to your amp with
both an  cable and an audio cable.
• When you use this function, be sure to set
your amp’s volume control to a suitable
level.
• Your amp may take several seconds to
startup, so you might not hear the first
few seconds of the first song/video.
Notes:
• To charge your iPod/iPhone battery, the
AC adapter must be plugged into a suit-
able wall outlet and connected to the RI
Dock’s DC IN jack.
• See your iPod/iPhone model’s instruction
manual for more information on battery
charging.
Setting the Remote Controller’s ID