Onkyo Remote Interactive Dock for iPod/iPhone DS-A4 - Manual (Page 12)

12
While the OSD mode is set to On, you can set
the RI Dock’s video output to PAL or NTSC.
If the onscreen display looks distorted on your
TV, try changing the TV system.
• While pressing and holding down the
[SETUP] button, press the VOLUME Up [ ]
button for more than 3 seconds to select
NTSC, or press the VOLUME Down [
] but-
ton for more than 3 seconds to select PAL.
■  Functions
Depending on your amp and generation of
iPod/iPhone, you may also be able to use the
following functions.
• System On Function
When you turn on your amp, the iPod/iPhone
turns on as well. With some amps, you may
need to press the [ON] button on your amp’s
remote controller’s twice to turn on the other
components in your system.
• System Off Function
When you turn off your amp, the iPod/iPhone
turns off as well.
• Auto Power On Function
*
If you start iPod/iPhone playback while your
amp is on Standby, your amp will automatically
turn on and select your iPod/iPhone as the
input source. Then, your iPod/iPhone will start
playback.
• Direct Change Function
*
If you start iPod/iPhone playback while listen-
ing to another input source, your amp will
automatically select your iPod/iPhone as the
input source.
• Timer Play
You can use your amp’s Timer function to turn
on your amp and iPod/iPhone and start play-
back at a specified time.
• Using Your Amp’s Remote Controller
You can use your amp’s remote controller to
control basic iPod/iPhone functions (see
page 14).
Setting the TV System
(European model only)
Other Functions
* If you use your iPod/iPhone model’s controls to start an
iPod/iPhone slideshow or video, these functions will not work,
so use the remote controller instead.
Note:
• Your amp may take several seconds to
startup, so you might not hear the first
few seconds of the first song/video.
Operating Notes:
• The RI Dock must be connected to your
amp with both an  cable and an audio
cable to use the  functions.
• If your amp doesn’t support the System
On, System Off, Auto Power On, and
Direct Change functions, you’ll need to
turn your amp on and off and select the
input source manually.
• Before you select another input source,
stop iPod/iPhone playback to prevent
your amp from selecting the iPod/iPhone
input source by mistake.
• If any accessories are connected to your
iPod/iPhone, your amp may not be able
to select the input source properly.
• While your iPod/iPhone is in the RI Dock,
its volume control has no effect. If you
adjust your iPod/iPhone model’s volume
control while it’s in the RI Dock, make sure
it’s not set too high before you reconnect
your headphones.