Olympus P-10 - Manual (Page 8)

8
Safety precautions
Preparation
Printing
For Your Information
Introduction
ENGLISH
NOTE
J Do not block the ventilation holes
Do not block the ventilation holes on the front and back of this
printer.Doing so may cause heat in the printer to build up, possibly
resulting in fire or electric shock.
Do not put the printer where there is poor ventilation, or on a soft
surface such as a rug or bed.
J Do not put the printer on an unstable surface
Do not put the printer on an unstable surface such as a shaky table.
Injury may result from the printer being dropped or falling. This
could also damage the printer or cause the printer to malfunction.
J Do not touch the non-user-serviceable parts inside the printer
Doing so may cause injury or burns. This applies especially to
children and those unfamiliar with the printer.
J Do not move the printer when the power cord is taut
Moving the printer when the power cord is taut may damage the
cord.
Using the printer when damaged may cause fire or electric shock.
When moving the printer, unplug and bundle the power cord.
J Do not unplug the printer by jerking or pulling on the power
cord
To unplug the power cord, hold it by the plug.Pulling on the cord
may damage it, possibly resulting in fire or electric shock.
J Unplug the printer for servicing
Always unplug the printer before servicing or performing
maintenance.
J Unplug the printer if it will not be used for an extended period
of time
Unplug the printer if it will not be used for an extended period of
time, such as while you are away on a long trip.
Otherwise, deteriorated insulation or current leakage may cause fire
or electric shock.
p10_e_000_bookfile.book Page 8 Monday, December 15, 2003 11:51 AM