Onkyo 7.2-Channel Network Audio/Video Receiver HT-RC360 - Manual (Page 49)

49
En
Picture Adjust
Using Picture Adjust, you can adjust the picture quality
and reduce any noise appearing on the screen.
To view the TV picture while setting, press ENTER. To
return to the previous screen, press RETURN.
■
Wide Mode *1*6
This setting determines the aspect ratio.
`
4:3:
` Full:
`
Zoom:
`
Wide Zoom:
`
Auto:
According to the input signals and monitor output
setting, the AV receiver automatically selects the
“4 : 3”, “Full”, “Zoom” or “Wide Zoom” mode.
See “Monitor Out” for details on the monitor output
setting (
➔
page 41).
■ Picture Mode *1
`
Custom:
All settings can be performed manually.
` Cinema:
Select when the picture source is a movie or alike.
`
Game:
Select when the video source is a game console.
`
Through:
Does not adjust picture quality (changes resolution).
`
Direct:
Does not adjust picture quality (does not change
resolution).
When video is output from HDMI OUT, it is
processed the same as “Through”.
With “Picture Mode”, you can change the following
settings to be suitable for the movie or game screen by one
operation; “Game Mode”, “Film Mode”, “Edge
Enhancement”, “Noise Reduction”, “Brightness”,
“Contrast”, “Hue”, “Saturation” or “Color
Temperature”.
■
Game Mode *2*3*4
`
Off
`
On
If video signal delay occurs during playback on a video
component (i.e., game console), select the corresponding
input source and set the “Game Mode” setting to “On”.
The delay will decrease but in return the picture quality
will become poor.
■
Film Mode *2*4
`
Video:
“Film Mode” detection is not applied and the input
signal is handled as a video source.
` Auto :
Detects whether the input signal is a video or a
movie. If it is a movie, the appropriate conversion is
applied.
The AV receiver will adjust to the picture source,
automatically converting it to the appropriate progressive
signal and reproducing the natural quality of the original
picture.
■
Edge Enhancement *2*4*5
` Off
` Low
`
Mid
`
High
With Edge Enhancement, you can make the picture appear
sharper.
■
Noise Reduction *2*4*5
`
Off
`
Low
` Mid
`
High
With this setting, you can reduce noise appearing on the
screen. Select the desired level.
■
Brightness *1*2*4
`
–50 to 0 to +50
With this setting you can adjust the picture brightness.
“–50” is the darkest. “+50” is the brightest.
■ Contrast *1*2*4
`
–50 to 0 to +50
With this setting you can adjust contrast. “–50” is the
least. “+50” is the greatest.
■
Hue *1*2*4
`
–50 to 0 to +50
With this setting you can adjust the red/green balance.
“–50” is the strongest green. “+50” is the strongest red.
■
Saturation *1*2*4
`
–50 to 0 to +50
With this setting you can adjust saturation. “–50” is the
weakest color. “+50” is the strongest color.