Optoma Home Theatre Projector - Manual (Page 49)

User Controls
47
English
Setup Settings
Signal
During the initial setup, adjustment of the color and image
quality should be performed. After this initial setup is
completed, the HD81-LV will automatically store the
settings for optimal image viewing.
The HD81-LV OSD is dependent upon the video source
signal. It has been designed to show a different OSD
display with each input. Please refer to table A and B below
for more details on available adjustments for each signal.
With the exception of the VGA and BNC connections, if the
HD81-LV is not receiving a signal from the input source
device, the OSD will only allow the System Setup module
to be adjusted.
T
ABLE
A
Composite S-Video RCA BNC
Video Decoder Video Decoder YPbPr YPbPr RGBsRGB
Type Auto YPbPr, RGBs, RGB
Color Space Auto, SDTV,
HDTV
Auto, SDTV,
HDTV
Pedestal 0IRE, 7.5IRE 0IRE, 7.5IRE 0IRE, 7.5IRE 0IRE, 7.5IRE
Horizontal -50~50 -50~50 -50~50
Vertical -7~7 -7~7 -7~7
Frequency -10~10 -10~10 -10~10
Phase 0~31 0~31 0~31
T
ABLE
B
VGA HDMI
YPbPr RGBsRGB
Type Auto YPbPr, RGBs, RGB
Color Space Auto, SDTV, HDTV Auto, SDTV, HDTV
Pedestal 0IRE, 7.5IRE DVI-PC, DVI-Video
Horizontal -50~50 -50~50
Vertical -7~7 -7~7
Frequency -10~10 -10~10
Phase 0~31 0~31
* Grey color blanks stand for N/A.
 Please exercise caution when adjusting the “Horizontal” and “Vertical”
as this may cause the loss of your image if the values are set out of range.
We recommend using this adjustment only if you cannot receive the input
signal.