Onkyo T-433 - Manual (Page 27)

27
Using the Timers —Continued
Notes:
• You can change each setting while it’s displayed by
using the TUNING/PRESET [ ]/[ ] buttons
(TIMER [ ]/[ ]).
• If a timer is off when you change a setting, it will be
turned on.
• When you’ve checked all of the settings, if there are
no changes, the previous display reappears.
• You can return to the normal display at anytime by
pressing the [TIMER] button.
You can set the sleep timer so that it automatically turns
the system off after a specified period.
Setting with the Remote Controller
■ Checking the Remaining Sleep Time
To check how much time there is left until the system
turns off, press the [SLEEP] button. Note that if you
press the [SLEEP] button again while the remaining
sleep time is displayed, you’ll shorten the sleep time by
10 minutes.
■ Canceling the Sleep Timer
To cancel the sleep timer, press the [SLEEP] button
repeatedly until the SLEEP indicator goes off.
Using the Sleep Timer
Press the [SLEEP] button repeat-
edly to set the sleep time.
The time decreases in 10-minute steps
each time the button is pressed (90, 80,
70, and so on).
Use the TIMER Up and Down
[
]/[ ] buttons to adjust the sleep
timer in 1-minute steps. The Up [ ]
button increases the time in 1-minute
steps up to the maximum of 99 min-
utes. The Down [
] button decreases
the time in 1-minute steps down to the
minimum of 1 minute.
The SLEEP indicator appears on the
display when the sleep timer has been
set. The specified sleep time is dis-
played for about 5 seconds, then the
previous display reappears.
TAPE /CDR
PRESET
VOLUME
VOLUME
MD
PRESET
CLOCK
SLEEP
INPUT
TIMER
ENTER
MEMORY REPEAT DISPLAY
RANDOM P MODE SCROLL
MUTING
SLEEP
/ button
SLEEP
*En_T433_02.fm Page 27 Tuesday, February 15, 2005 3:09 PM