Omega Speaker Systems 8 Channel Thermocouple USB Data Acquisition Module TC-08 - Manual (Page 47)

Technical reference 43
3.5 Troubleshooting
The following table lists each of the error codes described in the
usb_tc08_get_last_error section, and divides them into categories, so that you know
what to do in the event of a particular error occurring.
Error code Description Category
1 USBTC08_ERROR_OS_NOT_SUPPORTED P*
2 USBTC08_ERROR_NO_CHANNELS_SET P
3 USBTC08_ERROR_INVALID_PARAMETER P
4 USBTC08_ERROR_VARIANT_NOT_SUPPORTED P*
5 USBTC08_ERROR_INCORRECT_MODE P
6 USBTC08_ERROR_ENUMERATION_INCOMPLETE S
7 USBTC08_ERROR_NOT_RESPONDING S
8 USBTC08_ERROR_FW_FAIL S
9 USBTC08_ERROR_CONFIG_FAIL S
10 USBTC08_ERROR_NOT_FOUND S
11 USBTC08_ERROR_THREAD_FAIL S
12 USBTC08_ERROR_PIPE_INFO_FAIL S
13 USBTC08_ERROR_NOT_CALIBRATED S
14 USBTC08_ERROR_PICOPP_TOO_OLD S
Key
S Errors in this category indicate that a fault has occurred with the USB
TC-08 unit or your PC. Try disconnecting the USB TC-08, then
reconnecting it. If this does not work, restart your PC. If this does not
work, do the following:
1. Uninstall the software and restart the PC
2. Reinstall the software and restart the PC
3. If this does not work, download the latest version of the software
from
http://www.omega.com and install this, then restart the PC
4. If this does not work, contact [email protected]
P
P*
Errors in this category are handled internally within software
applications, and only developers need to be aware of their meanings.
Find a
routine which fails with one of these error codes.
Errors in this category are user-dependent and developers should make
sure that their application provides suitable error messages for users to
read in the event of an error occurring.