Omega Speaker Systems 8 Channel Thermocouple USB Data Acquisition Module TC-08 - Manual (Page 33)

Technical reference 29
3.3.3 New USB mode only
3.3.3.1 usb_tc08_set_channel
short usb_tc08_set_channel
(
short handle,
short channel,
char tc_type
)
Call this routine once for each channel that you want to use. You can do this any time
after calling
usb_tc08_open_unit . By default, all channels are disabled.
Arguments handle Specifies the USB TC-08 unit.
channel Specifies which channel you want to set the details for: this
should be between 0 - 8 (0 denotes the cold junction.)
tc_type Specifies what type of thermocouple is connected to this
channel. Set to one of the following characters: 'B', 'E', 'J',
'K', 'N', 'R', 'S', 'T.' Use a space in quotes to disable the
channel. Voltage readings can be obtained by passing 'X' as
the character.
Returns 0 Use usb_tc08_get_last_error .
1 Routine was successful.
Note: The CJC is always enabled automatically if a thermocouple is being used. When
no channels are active as thermocouples, the CJC can be optionally enabled or
disabled.