Olympus CAMEDIA C-160 - Manual (Page 10)

10
En
Getting started
Loading batteries
Use one CR-V3 lithium battery pack, or two AA (R6) NiMH batteries or
alkaline batteries.
• CR-V3 lithium battery packs cannot be recharged.
• Do not peel the label on a CR-V3 lithium battery pack.
• Manganese (zinc-carbon) batteries cannot be used.
Important
1
Make sure that:
• The lens barrier is closed.
• The monitor is off.
• The lamps on the right of the viewfinder are off.
2
Slide the battery compartment cover in
the direction of
a (the direction
indicated by the mark on the cover),
and lift it up in the direction of b .
3
Insert batteries in the direction shown in the illustration.
When using AA (R6) batteries
When using AA (R6 batteries),
also refer to the mark on the
bottom of the camera that
shows the correct way to insert
batteries.
When using a CR-V3 lithium battery pack
a b
4
Close the battery compartment cover so
that it pushes batteries down inside.
While pressing the
mark, slide the
cover in the direction of c .
• If you have difficulty closing the battery
compartment cover, do not force it. With the
battery compartment cover in place, press down
firmly the
mark firmly and push in direction c.
c
1 D395/C160_B-E1 2004.1.30 5:53 PM Page 10 (1,1)