Onkyo TX-DS797 - Manual (Page 59)

59
Controlling an Onkyo MD recorder
The connector of the Onkyo MD recorder must be connected to
the TX-DS797 (see page 14).
1. Press the MD MODE button.
The MD MODE button lights green.
2. Press the desired operation button.
The buttons shaded in the figure to the left are the operation
buttons that can be used to control an Onkyo MD recorder.
Operation buttons:
ON: Turns on and off the MD player (same as STDBY button on the
remote controller).
: Track down
: Track up
: Play
: Stop
: Fast reverse
: Fast forward
R (Rec): Record
: Pause
: Eject the disc
1 to 9, 0, --/---: Numeric keys
ENTER: Enters the settings
You may also use the following buttons:
VOL : Adjusts the volume at the TX-DS797
MUTING: Activates the muting function at the TX-DS797
MD
operation
buttons
Numeric keys
Using remote controller
SAT, CABLE, VCR, and TV MODE buttons
No preset codes are programmed into the SAT, CABLE, VCR, and
TV MODE buttons. You can use these buttons to program the
remote controller signals of other devices.
There are two methods. One method is selecting the name of a
different brand from the table, entering the setting number listed, and
calling up the pre-programming code (see page 61). The other
method is learning the commands from the other brand’s remote
control directly into this remote controller (see page 64).
When in the SAT, CABLE and VCR mode, you may use the
following buttons:
VOL : Adjusts the volume at the TX-DS797
MUTING: Activates the muting function at the TX-DS797
MD MODE
ON STDBY
VOL
MUTING
ENTER
VOL
MUTING
TV SAT
CABLE VCR