Omega Engineering DP3300 Series - Manual (Page 21)

DP3300 Series User’s Manual
Page20
FUNCTION DISPLAY SHOWS TO CHANGE
Latching or non -
'LATCH' for latching mode. Push ^v key to obtain alternate mode.
latching relay setup. 'NON LCH' for non latching mode.
Limit outputs prog-
LT1 N.O. or LT1 N.C Use ^V key to obtain
rammed as normally LT2 N.O. or LT2 N.C alternate mode.
open or closed LT3 N.O. or LT2 N.C
SETUP FOR RATE MONITOR:
If channel 2 is programmed to operate in RATE mode, then the following steps are performed during SETUP procedure:
FUNCTION DISPLAY SHOWS TO CHANGE
Time base for RATE 'rAtE tb' followed by previously Push ^v key to increment or decrement active
calculation (In seconds) programmed value e.g. '1.999' digit. Push key to make next digit active
Decimal point
dP 9999 Push ^v key to
placement dP 999.9 move decimal
dP 99.99 point to desired
dP 9.999 position.
Scaler
'SCALER' followed by preset scaler Push ^v key to increment or decrement
value e.g. 10.00024 with active digit active digit. Push key to change
flashing. active digit.
Division Factor
'DIV FAC' followed by preset division Push ^v key to increment or decrement
by preset division factor. (e.g. 12` active digit. Push key to
with active digitflashing). change active digit.
Limit 1
'CH1 LT1' followed by preset Limit 1 Push ^v key to increment or decrement
Limit 2 value e.g. 123.4 with active digit active digit. Push key to
Limit 3 flashing. active digit.
For limits 2 &3 CH1 LT2, CH1 LT3 NOTE: Limit3 is audio visual alarm only
followed by limit value. --- it has no relay output.
Relay deadband
'dEAdbd' followed by deadband Push ^v key to increment or decrement
value e.g. 0002 active digit. Push key to make
next digit active.
Limit outputs prog-
LT1 N.O. or LT1 N.C Use ^V key to obtain
rammed as normally LT2 N.O. or LT2 N.C alternate mode.
open or closed LT3 N.O. or LT2 N.C
SETUP FOR RPM MONITOR: