Omega Engineering DP3300 Series - Manual (Page 20)

DP3300 Series User’s Manual
Page19
FUNCTION DISPLAY SHOWS TO CHANGE
active digit flashing. active digit.
Division Factor
'dIV FAC' followed by preset Push ^v key to increment or decrement
division factor e.g. 12 with active digit. Push key to
active digit flashing. change active digit.
Limit 1 'CH1 LT1' followed by preset Limit 1 Push ^v key to increment or decrement
Limit 2 value e.g. 123.4 with active digit active digit. Push key to
Limit 3 flashing. active digit.
For limits 2 &3 CH1 LT2, CH1 LT3 NOTE: Limit3 is audio visual alarm only
followed by limit value. --- it has no relay output.
Relay deadband
'dEAdbd' followed by deadband Push ^v key to increment or decrement
value e.g. 0002 active digit. Push key to make
next digit active.
Latching or non -
'LATCH' for latching mode. Push ^v key to obtain alternate mode.
latching relay setup. 'NON LCH' for non- latching mode.
Limit outputs prog-
LT1 N.O. or LT1 N.C Use ^V key to obtain
rammed as normally LT2 N.O. or LT2 N.C alternate mode.
open or closed LT3 N.O. or LT2 N.C
Time base for RATE 'T BASE' followed by previously Push ^v key to increment or decrement active
calculation (In seconds) programmed value e.g. '1.999' digit. Push key to make next digit active
SETUP FOR HIGH AND LOW FREQUENCY MONITOR:
If the unit is setup as a frequency meter, then following SETUP steps are performed.
FUNCTION DISPLAY SHOWS TO CHANGE
Scaler
'SCALER' followed by preset scaler Push ^v key to increment or decrement
value e.g. 10.00024 with active digit active digit. Push key to
flashing. change active digit.
Division Factor
'DIV FAC' followed by preset division Push ^v key to inc rement or
decrement by preset division factor. (e.g. 12` active digit. Push key to
with active digit flashing). change active digit.
Limit 1
'CH1 LT1' followed by preset Limit 1 Push ^v key to increment or decrement
Limit 2 value e.g. 123.4 with active digit active digit. Push key to
Limit 3 flashing. active digit.
For limits 2 &3 CH1 LT2, CH1 LT3 NOTE: Limit3 is audio visual alarm only
followed by limit value. --- it has no relay output.
Relay deadband
'dEAdbd' followed by deadband Push ^v key to increment or decrement
value e.g. 0002 active digit. Push key to make
next digit active.