Oricom BB100 - Manual (Page 8)

- 8 -
Standby mode
When the handset is not in use is in the standby mode. The LCD will display:
Where:
1:
Handset assigned number
BB100: Handset name
10:37: Time of the day ( 10 AM, 37 minutes) (ex : 23:37 : 11 PM, 37 minutes)
Note: If power is disconnected from your phone, the clock will be inaccurate. When the power is
restored, it will be automatically reset the time to 12:00 and the date to 01/01. You need to set the correct time
and date when the power is turned on.
If you subscribe to your network operators Caller ID services, your phone clock will automatically set the time
and date when you receive CID from the network.
USING YOUR PHONE
To make and end calls:
1) Press “Talk” button and wait for dial tone. The In Use indicator
and
icon will appear in the display.
2) Dial your desired number on handset.
3) Speak into the microphone when the party answers.
4) To end the call, either press ‘Talk” or place the handset back on
the base. The In Use indicator and
icon will disappear.
Preparatory dialling (pre-dial)
Pre-dialling allows you to enter and modify a number before dialling.
1)
In standby mode (i.e. when the phone is not in use), enter the
telephone number from the numeric keypad. (up to 25 digits
allowed. If the number exceeds 12 digits, the last 12 digits are
displayed) you wish to dial; it will appear in the display.
2)
If you have entered a digit incorrectly, you can delete it by pressing
the CANCEL button.
3)
If you wish to delete the whole telephone number, press and hold
the CANCEL button for 3 seconds. The handset will return to
standby mode.
4) Press TALK button. The displayed number will be dialled.
5) To end the call, either press the TALK button or place the handset
back on the base.
Receiving external calls
• When you receive an incoming call both your handset and base will ring, provided that the ringers are
set to on. The icon will flash in the handset display and the In Use LED on the base will flash as
well.
• If you have subscribed to caller ID service, the New CID symbol (see LCD layout) blinks in the display.
The caller’s number (if available) is also displayed. The date and time of the call is displayed when OK
is pressed.
1 BB100 10.37