Omega Speaker Systems PCI-DAS1001 - Manual (Page 37)

8.4 COUNTER SECTION
Counter type 82C54
Configuration Two 82C54 devices. 3 down counters per 82C54, 16 bits each
82C54A:
Counter 0 - ADC residual sample counter.
Source: ADC Clock.
Gate: Internal programmable source.
Output: End-of-Acquisition interrupt.
Counter 1 - ADC Pacer Lower Divider
Source: 10 MHz oscillator
Gate: Tied to Counter 2 gate, programmable source.
Output: Chained to Counter 2 Clock.
Counter 2 - ADC Pacer Upper Divider
Source: Counter 1 Output.
Gate: Tied to Counter 1 gate, programmable source.
Output: ADC Pacer clock (if software selected), available at connector
82C54B:
Counter 0 - Pretrigger Mode
Source: ADC Clock.
Gate: External trigger
Output: End-of-Acquisition interrupt.
Counter 0 - User Counter 4 (when in non-Pretrigger Mode)
Source: User input at 100pin connector (CLK4) or internal 10MHz
(software selectable)
Gate: User input at 100pin connector (GATE4).
Output: Available at 100pin connector (OUT4).
Counter 1 - User Counter 5
Source: User input at 100pin connector (CLK5).
Gate: User input at 100pin connector (GATE5).
Output: Available at 100pin connector (OUT5).
Counter 2 - User Counter 6
Source: User input at 100pin connector (CLK6).
Gate: User input at 100pin connector (GATE6).
Output: Available at 100pin connector (OUT6).
Clock input frequency 10Mhz max
High pulse width (clock input) 30ns min
Low pulse width (clock input) 50ns min
Gate width high or low 50ns min
Input low voltage 0.8V max
Input high voltage 2.0V min
Output low voltage 0.4V max
Output high voltage 3.0V min
8.5 OTHER SPECIFICATIONS
Power consumption
+5V Operating (A/D converting to FIFO) 0.8A typical, 1.0A max
Environmental
Operating temperature range 0 to 70°C
Storage temperature range -40 to 100°C
Humidity 0 to 90% non-condensing
34