Olympus SP-610UZ - Manual (Page 37)

37 EN
Selecting the ISO sensitivity
1
Select the ISO setting option in the function
menu.
P P
0.0 0.0
AUTO
WB
AUTO
WB
200
ISO
200
ISO
100
ISO ISO
100
1/400 F3.3 F3.3 1/400
400
ISO
400
ISO ISO 200 ISO 200
MENU MENU
2
Use HI to select the setting option, and
press the A button to set.
Option Description
ISO Auto
The camera automatically adjusts
the sensitivity according to the
shooting scene.
High ISO Auto
The camera uses a higher sensitivity
compared to [ISO Auto] to minimize
blur caused by a moving subject or
by camera shake.
Value
The ISO sensitivity is fi xed to the
selected value.
In the ISO setting, although smaller values result in
less sensitivity, sharp images can be taken under fully
lit conditions. Larger values result in higher sensitivity,
and images can be taken at fast shutter speeds even
under low light conditions. However, high sensitivity
introduces noise into the resulting picture, which may
give it a grainy appearance.
Sequential shooting (Drive)
Pictures are taken sequentially while the shutter button
is held down.
1
Select the drive option in the function menu.
0.0 0.0
AUTO
WB
AUTO
WB
AUTO
ISO
AUTO
ISO
P P
Sequential Sequential
MENU MENU 14 M
44 N ORM
Option Description
o
One frame is shot each time the
shutter button is pressed.
j *1
Take sequential shots using the
focus, brightness (exposure) and
white balance set in the fi rst frame.
c
The camera takes sequential shots
at a faster speed than in [j].
d
The camera takes sequential shots
at approximately 10 frames/sec.
*1 The shooting speed varies depending on the settings
for [Image Size/Compression] (p. 39).
When set to [j], the fl ash (p. 34) cannot be set to
[Redeye]. In addition, when set to [ c] or [d], the
fl ash is fi xed to [Flash Off].
When set to [ c] or [d], [Image Size] is limited to
[n] or lower (for [c]), or [3] or lower (for [d]),
and the ISO sensitivity is fi xed to [ISO Auto].
When set to [j] , [Image Size] cannot be set
to [6]. Also, when set to [j] and [Image
Size] is [4] or [K], [Fine] cannot be set for
[Compression].