Onkyo 29344934 - Manual (Page 25)

25
Connecting the AV receiver
—Continued
By connecting both the audio and video outputs of your DVD player and other AV components to the AV receiver, you
can switch the audio and video signals simultaneously simply by changing the input source on the AV receiver.
The AV receiver supports several connection formats for compatibility with a wide range of AV equipment. The format
you choose will depend on the formats supported by your other components. Use the following sections as a guide.
For video components, you must make an audio connection and a video connection.
Video Connection Formats
Video equipment can be connected to the AV
receiver by using any one of the following
video connection formats: composite video,
component video, or HDMI, the latter offering
the best picture quality.
When choosing a connection format, bear in
mind that the AV receiver doesn’t convert
between formats, so only outputs of the same
format as the input will output the signal.
Audio Connection Formats
Audio equipment can be connected to the AV
receiver by using any of the following audio
connection formats: analog, optical, coaxial, or
HDMI.
When you connect audio equipment to an
OPTICAL or COAXIAL input, you must
assign that input to an input selector
(see page 42).
Audio signals received by the HDMI IN jacks
are output only by the HDMI OUT (Pass-
Thru). HDMI sources are not output by the
speakers connected to the AV receiver.
Connecting Audio and Video Signals to the AV receiver
: Signal Flow
Video
Video
Audio
Speakers (see page 20 for hookup details)
DVD/BD player, etc.
TV, projector,
etc.
Audio
Which Connections Should I Use?
IN
MONITOR OUT
DVD player, etc.
AV receiver
TV, projector, etc.
Component
Video Signal Flow Chart
HDMI
Composite Component HDMI
Composite
DVD player, etc.
AV receiver
TV, projector, etc.
Optical Coaxial Analog
Analog
Audio Signal Flow Chart
HDMI
HDMI
HT-S5200_En.book 25 ページ ２００９年３月９日 月曜日 午後４時３１分