Olympus DS-40 - Manual (Page 15)

15
1
Power Supply
When the recorder is not being used, turn the power off to reduce battery consumption to a
minimum. Even if the power is turned off, existing data, mode settings, and clock settings will
be maintained.
Turning On the Power
While the recorder's power is off,
slide the POWER/HOLD switch in
the direction indicated by the arrow.
The display will turn on, and, after “System
Check” appears, the power will be turned on.
The resume function will bring the recorder
back to the stop position in memory before
power was turned off.
Turning Off the Power
Slide the POWER/HOLD switch in the direction
indicated by the arrow for 0.5 seconds or longer.
The display shuts off and the power will be turned off.
The resume function remembers the stop position before
the power is turned off.
If the recorder is on and stops for 10 minutes or longer (default), the display shuts off and it goes into
power save mode. You can set the time to enter power save mode from among “5 min,” “10 min,”
“30 min,” “1 hour,” and “Off.” To exit power save, press any button.
Power save mode
Power Supply