Onkyo SKM-750XS R - Manual (Page 81)

81
Advanced Setup —Continued
This section explains items on the Hardware menu.
Note:
• This procedure can also be performed on the AV
receiver by using its [SETUP], [ENTER], and arrow
buttons.
Remote Control
■
Remote ID
When several Onkyo components are used in the same
room, their remote ID codes may overlap. To differenti-
ate the AV receiver from the other components, you can
change its remote ID from 1, the default, to 2 or 3.
Note:
• If you do change the AV receiver’s remote ID, be sure
to change the remote controller to the same ID (see
below), otherwise, you won’t be able to control it with
the remote controller.
Changing the Remote Controller’s ID
Analog Multich
■
Subwoofer Input Sensitivity
Some DVD players output the LFE channel from their
analog subwoofer output at 15 dB higher than normal.
With this setting, you can change the AV receiver’s sub-
woofer sensitivity to match your DVD player. Note that
this setting only affects signals connected to the AV
receiver’s DVD SUBWOOFER jack.
You can select 0dB, 5dB, 10dB, or 15dB.
If you find that your subwoofer is too loud, try the 10 dB
or 15 dB setting.
Hardware Setup
1 Press the [RECEIVER] REMOTE
MODE button, followed by the
[SETUP] button.
The main menu appears onscreen.
If the main menu doesn’t appear, make
sure the appropriate external input is
selected on your TV.
2 Use the Up and Down [ ]/[ ]
buttons to select “7. Hardware
Setup,” and then press [ENTER].
3 Use the Up and Down [ ]/[ ]
buttons to select an item, and
then press [ENTER].
The screen for that item appears.
SETUP
RECEIVER
ENTER
Number
buttons
Remote
indicator
4 Use the Up and Down [ ]/[ ]
buttons to select an item, and
use the Left and Right [
]/[ ]
buttons to change it.
The items are explained below.
5 When you’ve finished, press the
[SETUP] button.
Setup closes.
1 While holding down the
[RECEIVER] REMOTE MODE but-
ton, press and hold down the
[SETUP] button until the Remote
indicator lights up (about 3 sec-
onds).
2 Use the number buttons to enter
ID 1, 2, or 3.
The Remote indicator flashes twice.
(3 seconds)