beautypg.com

Connecting onkyo components, Connecting the power cord, Connecting onkyo – Onkyo SKM-750XS R User Manual

Page 40: Components, Connecting your components —continued, Dvd), Cbl/sat), Vcr/dvr), Auto power on/standby, Direct change

background image

40

Connecting Your Components

—Continued

With

(Remote Interactive), you can use the following special functions:

Auto Power On/Standby

When you start playback on a component connected via

, if the AV receiver is on Standby, it will automatically turn

on and select that component as the input source. Similarly, when the AV receiver is set to Standby, all components
connected via

will also go on Standby.

Direct Change

When playback is started on a component connected via

, the AV receiver automatically selects that component as

the input source. If your DVD player is connected to the AV receiver’s DVD IN (multichannel input), you’ll need to
press the [MULTI CH] button repeatedly and select Multich to hear all channels (see page 50), as the Direct Change

function selects the DVD IN FRONT L/R jacks.

Remote Control

You can use the AV receiver’s remote controller to control your other

-capable Onkyo components. You must enter

the appropriate remote control code first (see page 85). And remember to point the remote controller at the AV receiver
and not the other component.

Notes:

• Use only

cables for

connections.

cables

are supplied with Onkyo players (DVD, CD, etc.).

• Some components have two

jacks. You can con-

nect either one to the AV receiver. The other jack is
for connecting additional

-capable components.

• Connect only Onkyo components to

jacks. Con-

necting other manufacturer’s components may cause
a malfunction.

• Some components may not support all

functions.

Refer to the manuals supplied with your other Onkyo
components.

• Before connecting the power cord, connect all your speakers and AV components.

• Plug the end of the power cord into a suitable wall outlet.

• Turning on the AV receiver may cause a momentary power surge that might interfere with other electrical equipment

on the same circuit. If this is a problem, plug the AV receiver into a different branch circuit.

Connecting Onkyo

Components

Step 1: Make sure that each Onkyo component is connected to the AV receiver with an analog audio cable (RCA).

Step 2: Make the necessary

connections (see illustration below).

Step 3: If you’re using an MD or CDR component, change the Input Display (see page 48).

IN

IN

IN

IN

IN

IN

IN

IN 1(DVD)

OUT

OUT

COMPONENT VIDEO

Y

CB/PB

CR/PR

SUB

WOOFER

FRONT

SURR

SURR BACK

CENTER

CD

R

L

TAPE

CBL/SAT

CBL/SAT

VCR/DVR

VCR/DVR

DVD

DVD

R

L

R

L

S

V

MONITOR

OUT

S

V

REMOTE

CONTROL

ASSIGNABLE

COAXIAL

OPTICAL

1

(DVD)

2

(CBL/SAT)

1

(VCR/DVR)

2

(CD)

DIGITAL IN

ASSIGNABLE

ANTENNA

FM

AM

75

OUT

OUT

HDMI

IN 4

IN 3

(CBL/SAT)

(VCR/DVR)

(DVD)

IN 2

IN 1

ASSIGNABLE

OUT

IN 2 (CBL/SAT)

DOCK

(for DS-A1L)

L

R

FRONT

DVD

L

R

IN

CD

L

R

REMOTE

CONTROL

ANALOG

AUDIO OUT

L

R

ANALOG

AUDIO OUT

e.g., CD player

e.g., DVD player

Connecting the Power Cord

This manual is related to the following products: