Onkyo SKM-750XS R - Manual (Page 76)

76
Advanced Setup —Continued
Double Bass
With the Double Bass function, you can boost bass out-
put by feeding bass sounds from the front left, right, and
center channels to the subwoofer. This function can be
set only if the Subwoofer setting (step 4) is set to Yes,
and the Front setting (step 5) is set to Large in the
Speaker Configuration on page 74.
Note:
• These settings cannot be changed while headphones
are connected, speaker set B is on, or the multichannel
DVD input is being used.
Speaker Distance
With these settings, you can specify the distance from
each speaker to the listening position.
11 Use the Down [ ] button to
select “Double Bass,” and then
use the Left and Right [
]/[ ]
buttons to select:
On: Double Bass function on.
Bass from the front left and
right channels is also fed to
the subwoofer (default).
Off: Double Bass function off.
12 Press the [SETUP] button.
Setup closes.
1 Measure and make a note of the
distance from each speaker to
the listening position.
This setting is not set automatically by the Automatic
Speaker Setup function (see page 42).
These settings are set automatically by the Automatic
Speaker Setup function (see page 42).
2 Press the [RECEIVER] REMOTE
MODE button, followed by the
[SETUP] button.
The main menu appears onscreen.
If the main menu doesn’t appear, make
sure the appropriate external input is
selected on your TV.
3 Use the Up and Down [ ]/[ ]
buttons to select “2. Speaker
Setup,” and then press the
[ENTER] button.
4 Use the Up and Down [ ]/[ ]
buttons to select “2. Speaker Dis-
tance,” and then press [ENTER].
5 While “Unit” is displayed, use the
Left and Right [
]/[ ] buttons to
select “feet” or “meters”.
feet: Distances can be set in feet.
Range: 1 to 30 feet in 1-foot
steps.
meters: Distances can be set in
meters. Range: 0.3 to 9
meters in 0.3-meter steps.
6 Use the Down [ ] button to
select “Left” and use the Left and
Right [
]/[ ] buttons to specify
the distance for the front speak-
ers, then press the Down [
] but-
ton to select the next speaker.
7 Repeat step 6 for all speakers.
Note:
Speakers that you set to No or None in
the Speaker Configuration (page 74)
cannot be selected.