beautypg.com

Using headphones, Displaying source information, Using headphones displaying source information – Onkyo SKM-750XS R User Manual

Page 52: K (52), Utton (52), Common functions —continued

background image

52

Common Functions

—Continued

7

For private listening, you can connect a pair of stereo
headphones (1/4-inch phone plug) to the AV receiver’s
PHONES jack.

Notes:

• Always turn down the volume before connecting your

headphones.

• While the headphones plug is inserted in the PHONES

jack, the speakers set A and B are turned off.

• When you connect a pair of headphones, the listening

mode is set to Stereo, unless it was already set to
Mono, Stereo, or Direct, in which case it stays the
same.

• When the multichannel DVD input is selected, only

the front left and front right channels can be heard in
the headphones.

You can display various information about the current
input source as follows.

Note:

• This procedure can also be performed on the AV

receiver by using its [DISPLAY] button.

The following information can typically be displayed:

*1 When AM or FM radio is used, the band, preset num-

ber, and frequency are displayed.

*2 If the input signal is analog, or AM or FM radio is

selected, no format information is displayed. If the
input signal is PCM, the sampling frequency is dis-
played. If the input signal is digital but not PCM, the
signal format is displayed. Information is displayed
for about 3 seconds, then the previous display reap-
pears.

Using Headphones

ON/STANDBY

STANDBY

SPEAKERS B

A

PHONES

MULTI CH

DOCK

Displaying Source Information

Press the [RECEIVER] REMOTE
MODE button, and then press the
[DISPLAY] button repeatedly to
cycle through the available infor-
mation.

Input source &

volume*

1

Signal format*

2

or sampling

frequency

Input source &

listening mode

This manual is related to the following products: