Onkyo TX-DS696 - Manual (Page 29)

29
Enjoying music or videos with the TX-DS696
Though the TX-DS696 is often used to listen to the radio, it does not
show you its true ability until it is used to play music or watch
videos, DVDs, and the like. The TX-DS696 has the latest in state-of-
the-art features to play back today’s acoustic technologies with the
utmost in fidelity and power. From a two-speaker system to a five-
speaker system, you are assured a sound space that you can always
enjoy.
Listening with headphones
To listen with headphones, plug a pair headphones with a standard
stereo plug into the PHONES jack on the TX-DS696 front panel.
When you connect headphones, the unit will enter STEREO mode
automatically and no sound will be heard from the speakers.
If you have selected MULTI CH INPUT, you will hear sound only
from the FRONT L and R channels.
The headphone volume level can be adjusted at the Setup menu (see
page 42).
Note that the signal to the remote zone (Zone 2) will not be affected
whether or not headphones are connected.
Adjusting the bass and treble
You can adjust the bass and treble levels using the BASS and
TREBLE dials. This function only affects the front left and right
speakers. For multichannel sources, these dials will not work if the
tone control is set to “Off.”
Temporarily turning off the sound
To turn off the sound momentarily, such as when interrupted by a
phone call, press the MUTING button on the remote controller.
When pressed, “Muting” is displayed on the TX-DS696. Press the
MUTING button again to turn the sound back on.
PHONES
BASS TREBLE
HOME THEATER CONTROLLER RC-440M
STANDBY/ON
STANDBY
OFF ON
POWER
MASTER VOLUME
BASS TREBLE
AV RECEIVER TX-DS 696
PHONES FM AM PHONO C D TAPE DVD
REC OUT ZONE 2 ZONE 2 LEVEL CH LEVEL
VIDEO 3 VIDEO 4 VIDEO 2 VIDEO 1
VCR 2 VCR 1
AUDIO SELECTOR
TUNING PRESET SMART SCAN NAVIGATOR PRESET MEMORY FM MODE DISPLAY DIMMER
PUSH TO ENTER
DSP / MODE ADJ SETUP
RETURN
MASTER VOLUME
MUTING
PHONES TREBLE BASS
VOL
Basic operation
1. Press the input source (or input selector on the
remote controller) button.
Remote controller
2. Turn on the corresponding component and play the
media.
3. Adjust the volume.
FM AM PHONO C D TAPE DVD VIDEO 3 VIDEO 4 VIDEO 2 VIDEO 1
VCR 2 VCR 1
TX-DS696
Remote controller
Adjusting the main volume adjusts the volume level output from
all the speakers connected to the TX-DS696 together. If
headphones are connected, this also adjusts the volume heard
from the headphone speakers. To adjust the volume, either press
the VOL
buttons on the remote controller or turn the
MASTER VOLUME dial. To increase the volume, turn the dial
clockwise; to decrease the volume, turn the dial
counterclockwise. The volume can be set to Min, 1 to 79, and
Max.
INPUT
SELECTOR
buttons
Input source buttons
MASTER VOLUME