One for All Kameleon URC-6690 - Manual (Page 10)

OFA Kameleon™ 6-Device Hybrid Remote
8 Programming Device Control
NOTE: If the display turns off because of
inactivity, you must start the programming
sequence again by repeating this step.
2. Press 9 7 4 (Inner IR segments blinks
twice).
3. Press Arrow Up key to increase the
screen brightness (to decrease
brightness press Arrow Down key).
4. Press and release the SET key to lock in
the desired brightness. The remote will
exit the programming mode.
A DJUSTING H OW L ONG T HE S CREEN L IGHT
I S O N
The OFA Kameleon™ 6-Device Hybrid
Remote (URC-6690) allows you to control
how long the screen light remains on after
the last button is pressed. The display-on
time is set at the factory to run for about 8
seconds. To increase or decrease that time,
perform the following steps:
1. Press and hold SET until the two Inner
IR segments flash twice. The current
mode key will blink on and off during
programming.
NOTE: If the display turns off because of
inactivity, you must start the programming
sequence again by repeating this step.
2. Press 9 7 8 (Inner IR segments blinks
twice).
3. Use the following table to choose the
“light on” time:
4. The Kameleon display’s “On” time is
now programmed for the selected time
(in step 3).
PROGRAMMING DEVICE
CONTROL
The OFA Kameleon™ 6-Device Hybrid
Remote (URC-6690) is preprogrammed at
the factory to control a Sony TV, an RCA
DirecTV receiver, a Sony DVD player, a
Pioneer Audio Receiver, a Sony Tivo PVR
(VCR/PVR key), and a Pioneer CD player
(AUX Key). To control devices other than the
default brands, perform the following steps;
otherwise skip this section:
NOTE: For Combo Device control, see the
next section.
1. Turn on a device (e.g., TV, VCR or DVD
player) and, if applicable, insert media
(e.g., cassette or disc).
NOTE: Please read steps 2 through 4
completely before proceeding. Highlight or
write down the codes and device you wish to
program before starting step 2.
2. On the remote control, press a device
key once (i.e., TV, AUX, CBL/SAT, DVD,
AUD or VCR/PVR).
NOTE: Use the AUX key to program control of
an audio device such as a CD player, AMP,
HTIB (Home theater in a box), or a tuner.
Alternately, use the AUX key to program
control of a second device type (e.g., a
second DVD; see Re-assigning Device Keys
on page 14). Press…
…to set the
light for
1 4 seconds
2 8 seconds
3 12 seconds
4 16 seconds
5 20 seconds
Press…
…to set the
light for
OFA Kam 6 Hybrid Owners Manual.fm Page 8 Wednesday, March 30, 2005 3:09 PM