Oki lan 8100e - Manual (Page 49)

OkiLAN 8100e Network User’s Guide
Configuration - 49
IP Address Setup
If you only use TCP/IP and the OkiLAN has not yet been configured,
occasionally it may not be displayed on AdminManager. You can
configure the IP address of the OkiLAN by this function.
1. Select [IP Address Setup] from the [Setup] menu.
2. Set [Ethernet Address] and [IP Address] and select [OK].
bmp42.bmp
> The Ethernet Address (MAC address) is displayed during the
self-diagnostic test.
3. AdminManager asks whether you want to initialise the
network interface card or not. Select [Yes]. Even if you
select [No] here, the IP address that you set can be used
after turning the printer OFF and ON. The requirement to
turn your printer OFF and ON is dependent on the network
interface card.