ResMed Positive AirwAy Pressure Device S8 Series II - Manual (Page 11)

9 Cleaning and Maintenance
3
Remove the Data Card by gripping the end of the Data Card and pulling it out.
4
Store the Data Card in its protective folder when not in use.
5
Return the card in its protective folder to your clinician using a postal envelope.
Updating Settings on your S8 device
If your clinician has provided a Data Card with new device settings:
1
With the device in standby (Ramp or Settling) mode, insert the Data Card into the
Data Card slot. Updating will start automatically.
The “Card Inserted Please Wait” message is displayed on the LCD while
updating is in progress. Updating takes approximately five seconds.
The “Settings Success Remove Card” message is displayed on the LCD if the
settings were updated successfully.
Note: This message only appears once. If you re-insert the Data Card after you
have updated your settings, this message is not displayed.
2
Remove the Data Card from the S8 Series II.
3
Store the Data Card in its protective folder when not in use.
!
WARNING
If your clinician has told you to use this Data Card to update the settings on
your device and the “Settings Success” message does not appear, contact
your clinician immediately.
Cleaning and Maintenance
Daily
Disconnect the air tubing and hang it in a clean, dry place until next use.
Weekly
1
Remove the air tubing and wash it in warm water using mild detergent.
2
Rinse thoroughly, hang, and allow to dry.
3
Before next use, reassemble the mask and headgear.
4
Reconnect the air tubing.
Monthly
1
Clean the exterior of the S8 Series II with a damp cloth and mild liquid soap.
2
Check the air filter for holes and blockage by dirt.