ResMed Positive AirwAy Pressure Device S8 Series II - Manual (Page 10)

8
Messages on the S8 Series II LCD
Your clinician may have set your S8 Series II device to remind you about important
events, such as when to replace your mask, when to insert your Data Card (if your
device is Data Card enabled) and so on.
The reminder message is displayed on the LCD and is visible if the device is not
delivering therapy. The backlight on the LCD flashes when a message is displayed.
Your clinician can set any of the following reminders on your LCD:
Using the Data Card to Collect Data
If your clinician needs to review your treatment, they will ask you to use the Data Card
to copy data from your S8 Series II, and to return the card to them.
Copying Data onto the Data Card
1
Switch on the S8 Series II and wait until you see the standby (Ramp or Settling)
screen.
2
Hold the Data Card with the arrow facing up and insert it into the Data Card slot
until it stops. Data copying starts automatically.
The “Card Inserted Please Wait” message is displayed on the S8 Series II LCD
while data is being copied. Copying takes approximately five seconds.
The “Copy Complete Remove Card” message is displayed on the LCD when
copying has finished.
Message Description Action
INSERT
CARD May appear if your device is
Data Card enabled. Insert your Data Card and follow any
instructions that your clinician has given you.
When you have done this, the message will
disappear from the LCD. Pressing
(Ok)
will also remove the message.
REPLACE
MASK May appear when your mask
is due for replacement. Press (Ok) to remove the message
from your LCD, and replace your mask with a
new one.
CALL
PROVIDER May appear as a reminder to
contact your clinician, eg, to
discuss how your therapy is
going. Press (Ok) to remove the message
from your LCD, and contact your clinician.
REPLACE
FILTER May appear as a reminder to
replace the air filter on your
device. Press (Ok) to remove the message
from your LCD, and replace the air filter.
SERVICE
DUE May appear as a reminder to
return your device for service. Press (Ok) to remove the message
from your LCD, and contact your clinician.