RCA HD56W41 - Manual (Page 29)

Connections & Setup
Chapter 1 27
2. Use the number buttons and/or the arrows on your remote to enter your
zip code or postal code. Press OK when you’re finished.
Note: If your postal code contains letters, press the up and down arrow
buttons on your remote to enter letters, and press the right arrow button
to go to the next space. The left arrow button also moves the highlight
to the left.
Step 2: Configuring for Cable
The next series of screens asks you about your cable setup. To supply your TV
with the correct TV program listings, the GUIDE Plus+ system needs to know if
your TV is connected to a cable TV connection.
Notes: If you’re using a cable box, leave it on so you can receive program
information.
If you have two off-air antennas connected (one to ANTENNA A and one
to ANTENNA B) and you aren’t getting the guide listings, try swapping
the antennas
You cannot tune to digital channels from the GUIDE Plus+ system if you
have cable service or a cable box connected unless an off-air antenna is
connected to Antenna B.
1. If your TV is connected to cable, highlight Yes and press OK.
If your TV isn’t connected to cable, highlight No and press OK. (STEP 3:
Configuring for a VCR appears--go to page 28.)
2. If you have a cable box connected to this TV, highlight Yes and press OK
Notes: The next series of screens is very important because the GUIDE
Plus+ system must find the correct cable box information in order to
receive the correct TV program listings.
If you don’t have a cable box connected to this TV, highlight No and
press OK (STEP 3: Configuring for a VCR appears--go to page 28).
3. Highlight the channel on ANTENNA A where you have to tune your TV to
see cable box programming, and press OK (a screen appears reminding
you to connect your G-LINK cable to your TV and cable box).
Notes: If not using INPUT1 (VIDEO1/AUX), you must connect to ANTENNA
A not B.
Channel 03 is the most common.
Choose Video1/AUX if your cable box is connected to your TV with audio/
video cables instead of a coaxial cable. Go to page 8 for pictures of these
cables. If you choose Video 1/Aux, then connect the cable box to the
INPUT 1 on back of TV.