RCA 27F524T - Manual (Page 7)

Continues on next page...
get the Picture
The first part of connecting your TV is to get the picture, also known as a signal. The back
panel of your TV allows you to receive analog and digital channels by using the ANTENNA/
CABLE INPUT.
DIG•ANA
GUIDE
+•?
CH LIST
ABC DEF
GHI JKL MNO
PQRS TUV WXYZ
What You need to Know
• This television is equipped with a QAM (Quadrature Amplitude Modulation) tuner that
enables reception of unscrambled digital cable content. Check with your cable provider
for information about content availability in your area. Your TV also receives analog cable
TV channels.
• The Auto Channel Search screen in the Setup menu searches for both analog and digital
channels. Choose Cable as your source type. To complete a channel search now, go to
page 11.
• When you are ready to watch digital channels, make sure you are tuned to a digital
channel. Digital stations typically have a dash in their channel number because they can
contain subchannels, for example, 8-3.
When you are ready to watch an analog channel, make sure you are tuned to an
analog channel. Analog stations contain no more than three digits. Refer to page 11 for
information on analog and digital channels.
When using the input described above, press the ANTENNA
(DIG•ANA) button on the remote to toggle between digital and analog
channels. Refer to page 11.
Note: Another way to see if you’re tuned to a digital or analog
channel is to press the INFO button. This brings up the Channel
Banner screen, discussed on page 17.
Receiving Cable Channels
Coaxial cable
What You need
Coaxial cable from a cable outlet. Plug the coaxial cable into the
ANTENNA/CABLE INPUT to receive your analog and digital cable
channels.
ANTENNA
(DIG•ANA)
button
INFO
button
Chapter 1
Connections & Setup