Chapter 3 using the rn1 – RoyalTek RN1 User Manual
Page 16
16
Chapter 3 Using the RN1
3.1
RN1 Operating Basics
After fully charging the RN1, it is ready to be used. You can now turn it on and proceed to system
settings configuration.
3.2
To turn on the device:
1.
Sliding the battery switch to “ON”. (Default status OFF)
2.
Turn on your device by pressing the power button on the top right panel of the device.
After turn on the device, main page will display. This is also referred to the Favorite page.
3.3
To configure system settings:
If you intend to start using your RN1 at once, we recommend that you configure the language and time
zone settings first. The rest of the user preferences can be set up later.
1.
Tap “System” in the
right category bar
.