RCA LCDS2022B - Manual (Page 10)

Connections & Setup
6 Chapter 1 Graphics contained within this publication are for representation only.
Remove the Plate On the Back Panel
You need to remove the plate on the back panel in order to use the jacks. As the
picture to the left shows, push down on the tab and pull out the back plate carefully.
When you are finished connecting a component to the jacks, replace the plate.
VID1
S-Video In Audio In
L/mono R
Video In
Antenna/Cable
CABLE
OFF-AIR ANTENNA
OR
Connect Your Cable
Connect your cable or antenna to the Antenna/Cable jack on the bottom panel of the TV using
a coaxial cable.
VID1
S-Video In Audio In
L/mono R
Video In
AV component
Choose Your Connection
There are several ways to connect your television, depending on the components you want to
connect and the quality of the signal you want to achieve. The following are examples of some
ways to connect your TV. Choose the connection which is best for you.
Connection to AV Components
Using VID1
Connect a component, such as a VCR, DVD player or Satellite Receiver, to the TV using the
VID1 jacks. Connect an S-Video cable to the S-Video In jack at the bottom panel of the TV and
to the S-Video Out Jack on the component. Then connect audio cables to the Audio In L/mono
and R jacks on the bottom panel of the TV and to the Audio Output jacks on the component.
Note: If the component you are connecting only has a Video Jack, connect the component
to the TV’s Video In jack using a video cable.
16278150.01 Connections 12/11/03, 2:04 PM 6