beautypg.com

Chapter 1: connections & setup, Using the input button – RCA VR637HF User Manual

Page 14

background image

Chapter 1: Connections & Setup

12

Chapter 1

ON•OFF

Turns the power of the active device (either the TV or VCR) on or off.

PAUSE

Pauses playback and recording in VCR mode.

PLAY

Starts tape playback in VCR mode.

REC

Starts recording in VCR mode.

REV

Rewinds a tape. In Playback mode, pressing and holding REV starts reverse scan

playback. In Stop mode, pressing REV fast-rewinds.

SEARCH

In stop mode, displays Index Search and Go-To Search menus on-screen. Press this

button once to display the Index Search menu and a second time to display the Go-To Search
menu. In playback mode, press the SEARCH button to activate the Commercial Scan feature.
Each press after that advances the tape’s playback through 30 seconds of recorded material (up
to five minutes).

SPEED

Changes the recording speed (either SP or SLP).

STOP

Stops the active function of the VCR including tape playback, recording rewinding, and

fast-forwarding. Pressing the STOP button for several seconds also ejects an inserted tape.

TRACK +/– (up and down) buttons

Allows the manual reduction of streaks which may

appear on the picture during regular or slow-motion playback. Reduces picture “jitter” during
play-pause mode.

TV

Puts the remote control in TV mode. This button will automatically turn on most RCA, GE,

Proscan, and Scenium TVs.

VCR

Puts the remote control in VCR mode.

VOL+/VOL- buttons

Decreases or increases the TV volume.

Using the INPUT Button

Use the INPUT button to toggle through the available Video Input Channel sources (Video1 and
Video2) and regular broadcast signals. The Video Input Channels allow you to view images
from a device connected to your VCR (like a camcorder).

1.

Press the remote control’s VCR button to activate VCR mode. Make sure that the VCR is
turned ON.

2.

Press the remote control’s INPUT button to tune to the Video Input Channel. Video1
represents the rear A/V jacks and Video2 represents the front A/V jacks.

3.

Press the INPUT button again to tune back to the broadcast signal you were previously
watching through the VCR.