Maintenance – RIDGID R848 User Manual

Page 20

MAINTENANCE

REPLACING THE BELT

See Figures 19 - 20.
When replacing the belt, use the recommended replacement
belt only, RIDGID part number 570279001.
n

Lock the switch by placing the lock-off button in the

center position.

Remove belt cover screws.

Remove the belt cover.

Remove the old drive belt from the small pulley by turning

the large pulley in a counterclockwise direction. As you
turn the belt, pull and work it off the small pulley until it
has been completely removed from both pulleys.

Install the new belt over the large pulley. As you turn the

belt, push and work it onto the small pulley, turning the
pulley clockwise until the belt is in place.

Replace the belt cover.

Install belt cover screws and tighten securely, but do not

overtighten.

BATTERIES

The battery pack for this tool is equipped with nickel-cad-
mium rechargeable batteries. Length of service from each
charging will depend on the type of work you are doing.
The batteries in this tool have been designed to provide
maximum trouble-free life. However, like all batteries, they
will eventually wear out.

Do not disassemble battery pack

and attempt to replace the batteries. Handling of these
batteries, especially when wearing rings and jewelry, could
result in a serious burn.
To obtain the longest possible battery life, we suggest the
following:
n

Remove the battery pack from the charger once it is fully

charged and ready for use.

For battery pack storage longer than 30 days:
n

Store the battery pack where the temperature is below

80°F.

Store battery packs in a "discharged" condition.

BATTERY PACK REMOVAL AND
PREPARATION FOR RECYCLING

To preserve natural resources, please
recycle or dispose of batteries
properly.
This product contains nickel-cadmium
batteries. Local, state or federal laws
may prohibit disposal of nickel-
cadmium batteries in ordinary trash.

Consult your local waste authority for information regarding
available recycling and/or disposal options.

Fig. 19

Fig. 20

WARNING:

Upon removal, cover the battery pack’s terminals
with heavy-duty adhesive tape. Do not attempt
to destroy or disassemble battery pack or
remove any of its components. Nickel-cadmium
batteries must be recycled or disposed of properly.
Also, never touch both terminals with metal objects
and/or body parts as short circuit may result. Keep
away from children. Failure to comply with these
warnings could result in fire and/or serious injury.

PULLEY

SCREWS

BELT

COVER

PULLEY

BELT