RIDGID R848 - Manual (Page 13)

12 13
OPERATION
TO INSTALL BATTERY PACK
See Figure 6.
n
Lock the switch.
n Place the battery pack in the tool. Align raised rib on
battery pack with the groove inside the tool.
n Make sure the latches on each side of the battery pack
snap in place and battery pack is secured in the tool
before beginning operation.
CAUTION:
When placing battery pack in the tool, be sure
raised rib on battery pack aligns with the bottom
of the tool and latches into place properly. Improper
installation of the battery pack can cause damage
to internal components.
TO REMOVE BATTERY PACK
See Figure 7.
n
Lock the switch trigger on the tool by placing the switch
trigger in center position.
n Locate latches on side of battery pack and depress to
release battery pack from the tool.
n The battery pack will automatically disconnect in direction
to be removed when buttons are depressed.
n Remove the battery pack from the tool.
Fig. 6
Fig. 7
DEPRESS LATCHES TO
RELEASE BATTERY PACK
LATCH
BATTERY
PACK
LATCH