Roland Edirol R-05 - Manual (Page 67)

68
Playback
You can apply reverb when playing back a file on the
R-05. The reverb effect simulates the reverberation
that is characteristic of a performance in a large hall
or other space.
• You can’t record the sound with reverb
applied. Nor can you apply reverb to the
monitored sound during recording.
• You can’t apply reverb to the playback of a file
whose sampling rate is 88.2 kHz or 96 kHz.
• You can’t apply reverb if you’ve changed the
playback speed (p. 67)
1. Press [REVERB].
“REV” will be highlighted in the screen, and the
reverb effect will be applied.
Press [REVERB] once again to cancel the reverb
effect.
You can choose the desired type of reverb. These
settings can simulate a variety of acoustic spaces.
Applying Reverb to the Playback
Applying Reverb
Changing the Type of Reverb
Type Effect
HALL1
Simulates the reverberation of a concert hall.
This produces mild, spacious, and long
reverberation.
HALL2
Hall 2 produces a shorter reverberation than
Hall 1.
ROOM
Simulates the reverberation of a room. This
produces a bright, short reverberation that is
typical of a club or studio.
PLATE
Simulates the reverberation produced by a
plate reverb unit (a reverb device that uses
the vibration of a metal plate). This produces
a metallic reverberation with an extended
high-frequency range.
R-05-e.book 68 ページ ２０１０年２月１９日 金曜日 午後４時５５分