RadioLAN WNR834B - Manual (Page 108)

NETGEAR RangeMax™ NEXT Wireless Router WNR834B User Manual
8-12 Troubleshooting
v1.2, January 2007
This field determines which operating frequency is used. It should not be necessary to change
the wireless channel unless you notice interference problems with another nearby wireless
router or access point. Select a channel that is not being used by any other wireless networks
within several hundred feet of your router. For more information on the wireless channel
frequencies, see
“Wireless Communications” in Appendix B .
5. Set the Mode to g and b.
6. For Security Options, select None.
7. Click Apply to save your changes.
8. In the main menu of the WNR834B router, under the heading Advanced, click
Wireless Settings.
9. Make sure the checkboxes are selected for Enable Wireless Router Radio and Enable SSID
Broadcast.
10. Click Setup Access List.
11. Make sure that the checkbox is not selected for Turn Access Control On.
12. Configure and test your wireless computer for wireless connectivity.
Note: If you are configuring the router from a wireless computer and you change the
router’s SSID, channel, or security settings, you will lose your wireless
connection when you click Apply. You must then change the wireless settings
of your computer to match the router’s new settings.
Figure 8-2