RCA DRC105N - Manual (Page 34)

34
No sound or distorted sound
• Make sure your player is connected properly. Make sure all cables are securely inserted
into the appropriate jacks.
• You may need to readjust the Digital Output setting (from the Sound menu — page 31). If
you selected DTS and your DVD player isn’t connected to a DTS decoder or receiver,
either you won’t hear any audio or it will be distorted. Also, if you’ve connected a DTS
receiver or decoder and chose the correct setting in the Digital Output menu, but the disc
doesn’t support the DTS audio format you won’t hear any audio or you’ll hear
distorted audio.
• Turn your TV to its Video Input Channel (go to page 11).
• Sound is muted when you’re using search features (fast forward, reverse, frame advance,
etc.).
• If you connected an audio receiver to your DVD Player, make sure you chose the correct
input setting on the receiver.
Remote control won’t work
• You might be in the wrong mode.To operate your DVD Player, press the DVD button on
the remote before you press any other buttons. If you’re operating the TV, press the TV
button first, etc. (this remote operates most RCA, GE, and Proscan TVs).
• Check battery installation— the direction of the + and – on the batteries must match
information in battery compartment cover.
• Insert new batteries in the remote.
• Operate the remote control at a distance of no more than 20 feet.
• Remove any obstacles between the remote and the DVD Player. If your DVD Player is in
an entertainment cabinet, the glass doors might obstruct the remote control from
operating the DVD Player. Open the doors.
• Drain the remote’s microprocessor — remove the batteries; press and hold the 1 button
for 60 seconds; replace the batteries and try the remote again.
Can’t advance through a movie
• You can’t advance through the opening credits and warning information that appear at the
beginning of movies because the disc is programmed to prohibit that action.
The invalid icon appears on screen
The feature or action cannot be completed at this time for one of the following reasons:
• The disc’s software restricts it.
• The disc’s software doesn’t support that feature (e.g., angles).
• The feature is not available at the moment.
• You’ve requested a title or chapter number that is out of range.
The picture is distorted
• Did you connect your VCR to the DVD Player? Disconnect it, and connect the VCR
directly to the TV and the DVD Player directly to the TV. See chapter 1 for correct setup
and connection information.
• The disc might be damaged.Try another disc.
• If you’re using
FORWARD or REVERSE buttons, it is normal for some distortion to appear
while scanning.
Additional Information