Radio Shack CD Player - Manual (Page 23)

23
• After dubbing, if a program is stored,
both g of the PLAYBACK tray and g/
ENTER of the RECORD/PLAYBACK
tray allow you to play the programmed
tracks.
Dubbing a CD from a Selected
Track to the Last Track
Instead of dubbing the entire source disc
from the beginning to the end, you can dub
tracks from a selected track to the last track.
You can select from the first track to the last
track so the CD recorder dubs all the disc
yet it does not finalize the disc in the
RECORD/PLAYBACK tray at the end of the
dubbing.
1. In the stop mode after installing discs,
select the track you want to start from.
2. Press DUBBING MODE to select a
dubbing speed then press g/ ENTER .
3. At the end of the dubbing, PMA
WRITE then COMPLETE appears.
4. Repeat Steps 1–3 above if you want to
dub additional tracks.
Basic Recording
This section describes the basics of
recording from external sources.
1. Set a recordable CD-R/RW disc in the
RECORD/PLAYBACK tray. When a
blank disc is set in the RECORD/
PLAYBACK tray,
BLANK appears.
2. Select the source to be recorded. Every
time you press INPUT SELECTOR , the
input changes as follows:
DIGITAL OPTICAL ( OPTICAL
and DIGITAL light at the right of the
peak level meter): use to record from a
source connected to the
DIGITAL IN
( OPTICAL ) terminal.
DIGITAL COAXIAL ( DIGITAL
and COAXIAL light at the right of the
peak level meter): To record a source
connected to the
DIGITAL IN
( COAXIAL ) terminal.
ANALOG ( ANALOG lights at the right
of the peak level meter): use to record
from a source connected to
LINE IN
jacks.
Note: If you select a digital input which
is not connected to the CD recorder,
D-UNLOCK briefly appears.
3. Adjust the recording level. See “Setting
the Recording Level” on Page 24.
4. Select the mode of track number
assignment by pressing AUTO/
MANUAL . See “Assigning Track
Numbers to Recordings” on Page 25.
5. Press RECORD . BUSY then READY
appears. The CD recorder enters record
pause mode.
†
and REC flashes.
6. Press g/ ENTER of the RECORD/
PLAYBACK tray to start recording. Play
the source to be recorded.
If the CD recorder detects copy-prohibit
signals during recording,
CAN’T
COPY appears and recording stops.
7. Press
†
to temporarily pause recording.
To restart recording, press g/ ENTER .