Riccar R-SERIES R500 R800 - Manual (Page 7)

6
Operation
Attaching the handle
The vacuum cleaner and the handle are packed
separately.
1. After first removing the handle screw [Fig. 1],
position the handle behind the vacuum cleaner
and level with the top of the unit. Hold the power
cord down and away from the vacuum while the
handle is being attached [Fig. ]. Make sure that
the switch on the handle is positioned toward
the front of the vacuum cleaner.
. On the bottom of the handle are two “T-shaped”
rails that slide forward onto two guides located
on the top of the vacuum cleaner. Line up the
handle so that the “T” rails will slide into the
guides and push the handle forward [Fig. ].
. Insert the handle screw and tighten securely.
4. Attach the power cord at the clip located on the
upper cord hook [Fig. 4].
5. Turn the upper cord storage hook to the upright
position and wind the power cord around the
cord storage hooks when storing the vacuum
cleaner.
Fig. 1
Fig.
Fig.
Fig. 4