Razor Electric Punk - Manual (Page 14)

14
Figure 10a. Figure 10b.
If the belt requires tensioning, loosen the two screws and the locknut (A
in Figure 10b) and turn the adjusting screw (B in Figure 10b) in 1/8 to
1/4 turn increments until the desired tension is attained. Be careful not
to over tighten the belt!
Once the belt tension is correct, retighten the screws and locknut to
secure the adjusting mechanism.
6D. Changing a tire. Changing a tire or repairing a flat requires
removal of the wheel from the frame (rear) or fork (front). The following
sequence shows how to remove the rear wheel with the brake and drive
system. The procedure for removing the front wheel is not shown
because it only requires the removal of the axle.
1) Remove the brake anchor screw as shown in Figure 11a. The brake
anchor will disengage from the swingarm with the cable and return spring
still attached. You do not need to loosen or detach the brake cable.
2) Loosen and remove the rear axle as shown in Figure11b.
3) With the axle removed, slip the wheel up to release tension on the belt as
shown in Figure 11c.
4) Slip the belt over the swing arm and remove the wheel as shown in
Figure 11d. Watch the spacers! They may come off when the axle is
removed. There are two on the belt-side and one on the brake side
between the brake cover and the wheel.
5) The wheel is a two-part assembly and must be taken apart to remove the
tire and tube. Loosen the screws and nuts (shown in Figures 11e and 11f)