Razor Electric Punk - Manual (Page 13)

13
NOTE: The brake system requires a break-in period. You may
have to repeat procedure 6F often during the first several hours of use.
Repeat as necessary from thereafter to maintain proper brake function.
6B. Brake lever reach adjustment. The Electric Punk is supplied with
a brake lever that adjusts to accommodate a variety of hand sizes. To
adjust the brake lever so it is easier for smaller hands to operate the
brake, turn the screw in the direction marked “B” in the photo below.
Leave enough gap between the handlebar and lever to assure proper
brake function. To readjust for larger hands, turn the screw in the
direction marked “A” as shown in Figure 9 below.
Figure 9.
WARNING: Always test the brake function whenever making any
adjustment to the braking system.
WARNING: Brakes are subject to normal wear and tear. Although
the brakes are pre-adjusted at the factory and should not require
additional adjustment at the time of assembly, it is the responsibility of
the user to periodically inspect the brakes for excess wear. If you do
not understand how to adjust the brakes, we strongly recommend you
seek the help of a qualified mechanic. If the brakes are not properly
adjusted the brakes may fail and you can be seriously injured.
6C. Drive belt tension adjustment. The Electric Punk is supplied with
a self-tensioning drive belt that, under normal circumstances, should
never require adjustment. However, should the drive system become
loose, it could cause the belt to slip over the teeth of the timing pulleys.
If you suspect the belt is loose, with the power switch off, check the
tension by pushing against the belt as shown in Figure 10a. It should
deflect only very slightly under light pressure.