RCA 27F534T - Manual (Page 12)

INPUT
button
S-Video Connection
Back of TV
VIDEO OUT VIDEO IN COMPONENT IN VIDEO2 IN
S-VIDEO IN
ANTENNA/CABLE
ANALOG INPUT
ANTENNA/CABLE
DIGITAL INPUT
VIDEO
INPUT
L R
AUDIO
VIDEO
OUTPUT
S-VIDEO
OUT
S-VIDEO
IN
L R
AUDIO
L R
AUDIO
Device
2
3
Go to page 5 for
instructions on
getting a signal.
Connecting the Device
This connection allows you to connect a device that has an S-Video jack. S-Video
provides a clearer picture than the Video jack. Refer to the illustration which uses
S-Video and audio cables.
1. Connect your cable and/or antenna as described on page 5.
2. Connect your S-Video cable.
The S-Video cable fits into a special shaped jack which is labeled S-VIDEO IN.
Connect the S-Video cable to the jack on the TV and the jack on the device.
3. Connect your audio cables.
Connect the audio (white and red) cables to the R and L AUDIO jacks on the TV
and to the audio output jacks on the device. Just match the colors.
Viewing the Picture from the Connected Device
The device in this example could be a VCR, DVD player, satellite receiver or cable box.
It is connected to the TV’s S-Video jack. To view this device:
1. Turn on the TV and the device.
2. Press the INPUT button on the remote control to toggle through the Video Input
Channels until you see SVID2 displayed in the channel banner.
Remember: When you use the S-Video connection described here, you cannot use
the Video jack from the VIDEO 2 IN input for a connection at the same time.
Audio cables
S-Video cable
INPUT
button
Connections & Setup
10 Chapter 1