Radio Shack 43-3827 - Manual (Page 30)

The Integrated Answering Device
30
2. Press VOL/SEL/ # or VOL/SEL/ $ until the
correct day is announced. The numbers [ ]
through [
] are displayed on the base.
3. Press SET/RING to select the day.
4. Press VOL/SEL/ # or VOL/SEL/ $until you hear
the correct hour setting. The numbers [ ]
through [
] are displayed on the base as each
hour is announced.
5. Press SET/RING to select the hour.
6. Press VOL/SEL/ # or VOL/SEL/ $ until you hear
the correct minute setting. The numbers [ ]
through [ ] are displayed on the base as each
minute is announced.
7. Press SET/RING to select the minute.
8. Press VOL/SEL/ # or VOL/SEL/ $ until you hear
the correct AM or PM setting.
The message counter displays [ ] or [ ].
9. Press SET/RING to select the AM/PM setting.
You hear a confirmation tone, then the
announcement “Time” and the time and day are
announced for your review. After a few seconds,
the system announces “To set security code, press
menu again”.
Setting a Personal Security Code (PIN)
To play your messages from a remote location, you
need to enter a two-digit Personal Identification
Number (PIN) code (01-99). To select a PIN,
perform the following steps: Ô
1. Press MENU twice in standby mode.
“Security code” and the current PIN code is
announced as it is displayed on the base.
Ô
NOTE
Ô
The PIN code is set to “80”
when you purchase your
phone.
43-3827/3870.FM Page 30 Monday, June 2, 2003 11:02 AM