Safety precautions – Remington 489 User Manual
Page 7
489-28
489-26
489-25
Safety Precautions
5
G 018
G 018
G 018
G 018
3.
NEVER make fastenings in spalled or cracked areas.
2.
NEVER attempt to drive power fasteners into very hard or brittle materials
including, but not limited to cast iron, glass, tile, stone, brick, or hardened steel.
Materials of this type tend to shatter and create hazard from flying particles.
4.
NEVER drive power fasteners into thin or easily penetrated material unless it
is backed by concrete or steel. When in doubt, such as when base material is
concealed, conduct a Center Punch Test (See page 4). Check continually to
avoid fastening into unsuitable material, especially in older buildings.
5.
DO NOT fasten thru or within 1/2" of predrilled or pre-punched holes.
489-27
CAST IRON
GLASS
489-24
TILE
BRICK
482-33
G 018