Remington 489 - Manual (Page 15)

489-40
Operation
13
30
489-
WATER
489-33
489
489-41
5. Place the muzzle of tool perpendicular to work surface without tilting the tool.
Push tool against work surface until sliding action of barrel stops.
6. Squeeze trigger to set power fastener. Be sure to keep pressure on tool during
this operation.
7. After fastening is made, slide barrel forward rapidly. This motion ejects the
spent powder load and resets the piston for the next fastening. Make sure spent
load has ejected from tool.
8. Should the tool fail to fire, hold the muzzle firmly against the work surface for
30 seconds. Release the trigger and remove pressure on the tool while holding
the muzzle against the work surface. Again press the tool firmly against the
work surface and pull the trigger. If the tool still fails to fire, hold the tool firmly
against the work surface for another 30 seconds before unloading and carefully
discarding the misfired powder load into water or oil.
90˚