RCA DECT 00023265 - Manual (Page 25)

25
Making Call in the Speakerphone mode (from the handset)
1. Press the Speaker button to activate the speakerphone on the first
available line.
-OR-
Press the LINE 1 or LINE 2 soft key to select a specific line. The handset
will activate the ear piece.
2. Press the Speaker button to switch to speakerphone mode.
3. Wait for a dial tone then dial the phone number.
4. Press the
End button when finished.
Making Calls with the Optional Headset
1. Plug the headset into the Headset jack on the side of the base or side of
the cordless handset.
2. Adjust the headset to rest comfortably on top of your head or over
your ear.
3. Move the microphone to approximately 2 to 3 inches from your mouth.
4. For the base, press the
Headset button on base and the phone
automatically selects first available, if both lines are available, Line 1
will be used.
5. For the cordless handset, press the Talk button.
6. Wait for a dial tone, and then dial the phone number.
7. Press
Headset button (on base) or End button (on handset) when
finished.
CAUTION: Use only Thomson Inc. 5-2425 headset that is
compatible with this unit.
NOTE: If the headset is not connected (or if not completely inserted into
headset jack), an error tone is heard when the Headset button is pressed.
Pre-dialing
1. With the phone idle, manually enter the telephone number. The
telephone number shows in the display.
2. Press the DIAL soft key (on base only), Speaker button, Talk button
(handset only), or Line 1 or Line 2 button to take a line, and then the
telephone number will be dialed out.
Answering a Call
For cordless handset:
1. Press the
Talk button to answer the call in receiver mode,
-OR-
2. Press the Spk button to answer the call in speakerphone mode,
-OR-
3. Press the corresponding LINE soft key to answer the call in receiver
mode.
4. When finished, press END button.
Telephone Operation