RCA 25001 - Manual (Page 10)

10
3. Press the FLASH/EDIT button to enter into
the programming mode.
4. Press the or button to select the
desired flash time (100 / 200 / 300 / 400 /
500 / 600 / 700 / 800 / 900 msec).
5. Press the MENU/OK button to confirm/ You
will long beep, and the display shows SAVED,
then returns to the previous menu.
LCD Contrast
You may program the display contrast when
necessary. The default setting is level 3.
1. In standby mode, press the MENU/OK button.
2. Press the or button to go to LCD
CONTRAST. The display shows LCD
CONTRAST RESET.
3. Press the FLASH/EDIT button to enter the
programming mode.
4. Press the or button to select the
desired contrast (1/2/3/4/5).
Note: Level 1 represents the minimum contrast, and
level 5 the maximum. During selection, the contrast
changes according to the level selected.
5. Press the MENU/OK button to confirm. You
will hear a long beep, and the display shows
SAVED, then returns to the previous menu.
Reset
Use the RESET option to reset the unit to the
factory defaults.
Note: This setting does not affect the names and
numbers stored in the directory memory.
1. In standby mode, press the MENU/OK button.
2. Press the or button to go to RESET. The
display shows RESET NO YES.
3. Press the FLASH/EDIT button to enter the
programming mode. The display shows:
4. To reset to the factory default, press or
button to move the pointer to YES, then
press MENU/OK. You will hear a long beep,
and the unit returns to the READY mode.
Connections & Set Up
FLASH TIME
600 MS
LCD CONTRAST
RESET
LCD CONTRAST
LCD CONTRAST
RESET
RESET
NO YES