Radio Shack HandsfreePhone withCallerID/CallWaiting - Manual (Page 9)

9 Phone Operation
Leave PULSE/TONE set to
TONE . If the dial tone contin-
ues, you have pulse service.
Set
PULSE/TONE to PULSE .
5. Press TALK to hang up.
SETTING THE
RINGER VOLUME
You can select one of two volume
settings. Set
RINGER H/L on the top
of the phone to the desired ringer
setting (high or low).
STORING YOUR AREA
CODE
You can store your local area
code in the phone’s Caller ID
memory so it does not store the
area code if the received call is
from your local area. If for some
reason you need to dial the area
code (or store it in the memory),
you can add it afterwards. See
“Dialing Numbers from a Caller ID
Record” on Page 13.
Note: If your calling area requires
10-digit dialing including area
code, do not enter the area code
but leave this option blank.
Follow these steps to store your
area code.
1. Hold down CALL BACK/FLASH
for about 4 seconds.
2. Enter your three-digit area
code. If you make a mistake,
press
REDIAL/PAUSE to clear
the entry, then enter the cor-
rect code.
3. Press CALL BACK/FLASH to
store the area code.
ˆ
Phone Operation
Before you use the phone, put on
the headset and adjust it as need-
ed.
MAKING AND
RECEIVING CALLS
To make a call, press TALK . TALK
appears. Listen for the dial tone,
then dial the number. The number
appears on the display as you dial
it.
Note: o appears when you press
and H appears when you
press # .